How to Use a Pneumatic Finish Nailer and Air Compressor

Share the joy
  •  
  •  
  •  
  •  
  •  
  •  
  •  

Today I will introduce you to a 2 gallon compressor and pneumatic finish nailer. I use the Campbell Hausfeld 2 gallon compressor with Pneumatic Finish Nailer. I bought the kit when they were sold at Lowe’s for $ 69! A good price for this set is $ 89. There are many different brands out there and I’m sure they have different features and capabilities, but frankly I was happy with my setup that I had 2 years. Other kits can cost up to $300. The only drawback to this setup is that they can not be used for frame (wall construction house structure.) However, so far I have no need to do that.

How to Use a Pneumatic Finish Nailer and Air Compressor

Pneumatic Finish Nailer and Air Compressor

The finish nailer works very well on campus, truncated, board and flooring, wainscoting, wood and other small projects.

Compressor is a relatively simple tool. When returning, air accumulates in the chamber until it reaches a maximum of 110 psi.

Pressure gas pipe enters can be controlled by the control buttons. I often use my compressor and nail about 90 psi. But, if the nails are going too far into the woods, I can turn it down to 80 psi. Or if the nail will not stay far enough I’ll make it up to 100 psi. With continuous use, the pressure will drop. When the pressure is low enough, the compressor will start itself back up to increase the pressure again.

On / off button on my compressor is in the back.

The finish nailer small brad nails hold up to 2 “in length and” U “shaped sleeve. They are held in the magazine. The safety tips on nail must be pressed into the wood before a nail will burn. If not, the gun would not discharge.

While the use of nails and compressed it is very important to use safety glasses and ear protection.

When you are finished using the compressor, it is important to release all the air from the compressor. If you do not release air, moisture can build up and corrosion cracking. Start by reducing the pressure by adjusting down. Then pull the safety valve ring. It will close automatically, so you will need to drag it a few times or keep it open. I also remove the valve at the bottom of the tank to make sure it is completely empty before storing. Then I retorted van in.

After the tank is empty, drop pipe from nails. Add one or two drops of oil soaked up and the air inlet on the nail to keep it well lubricated. Cover the inlet and then you can store nails and compressors.

More information about Finish Nailer and Brad Nailer, please click bradnailer24h for more details.

Speak Your Mind

*